Call for Immediate Service(503) 300-4387

Leak Prevention Tips And Tricks

How To Detect Pipe Leaks

Water damage can be detrimental to your home. Don’t wait for a plumbing leak to creep up on you. Stop water damage from happening to your home by being proactive. If you’re looking for a Lake Oswego plumbing service, My plumbing Lake Oswego is your best bet.

Leak detection is the best way to stop leaks in their tracks and save your home. Because we know that finding leaks before they become a problem isn’t always the easiest task, we put together some helpful tips to help you stop leaks before they do some serious damage, take note of these tips listed below.

1. Check The Toilets

The first thing you’ll want to do is to check your toilets. The toilets in your home use up a large amount of water as it is. When there’s a leak within a toilet, the water usage may soar even higher. 

To detect a leak within a toilet, the first step is to remove the lid from the tank behind it. Listen for any hissing or dripping noises. If you hear those sounds, try to locate the leak and remedy it.

If there’s no noticeable hissing noise, add red food coloring into the tank of the toilet. You’ll only need to add in a couple of drops. Wait a few minutes and then check the bowl of the toilet. If the water in the toilet turns pink, there’s got to be a leak somewhere in your toilet tank.

2. Check Your Hot Water Tank

Now, head over to your hot water tank and check the pressure relief valve. This valve might be inside a drain, making it hard to detect the leak. Remove the drain pipe to find the leak.

If removing the drainpipe isn’t an option, then listen closely for that same hissing sound that you listened for with the toilets. If you hear hissing noises, there’s a leak. You should call a professional plumber if you detect a leak within your hot water tank. 

Another way to check for a leak associated with the hot water tank is to look for sitting water near the bottom of the tank. Also, check for moisture on the bottom of the discharge tube. 

3. Check Your Meter

To check the meter line, first, locate the shut-off valve by the house. Shut it off temporarily, and then remove the lid from the meter and watch the dial. 

If the lid for the meter isn’t visible, then try brushing around some of the dirt and other debris located around it. Dirt sometimes builds up and covers the meter. Once you get the lid off, look to see if the meter is still turning. 

If it is, the leak is between the meter and your house or a leaking valve, which is common for the older bronze gate valves. If this is the case, there’s a chance that the leak is inside your house. To determine where the leak is at, first, walk the length between the meter and the shut-off valve. Be on the lookout for soft or muddy areas. Once you’ve located this spot, it’s best to call in a professional plumber.

4. Check Outdoor Hose Bibs

Now you’ll want to check the hose bibs located outside your house as well. Most homes have one at the front of the house and one at the back. But to be safe, make sure these are the only two that your home has. 

Once located, take a screwdriver and place the metal part of it on the metal portion of the hose bib. Then take your thumb’s knuckle and place it at the other end of the screwdriver. Place your ear on your knuckle. This works like a stethoscope. If there’s a leak that’s not visible, you’ll be able to hear it. Do this with all hose bibs located outside. 

Leave a Reply

Your email address will not be published. Required fields are marked *